Rating
| Concentration | 20 °C | 50 °C | Remark |
|---|---|---|---|
| 10 % wet | A | A | |
| 97 % | – | – |
Material comparison at 20 °C
Resistance overview
ECTFE/ETFE shows very good resistance (A) to Chlorine at 10 % wet at 20 °C, meaning the material remains essentially unaffected by this chemical under standard laboratory test conditions. The rating remains stable between 20 °C and 50 °C, which means this material can also handle moderately elevated process temperatures without additional risk.
Application context
Chlorine is commonly encountered in waste treatment and bleaching. ECTFE/ETFE (Ethylene chlorotrifluoroethylene / ethylene tetrafluoroethylene) is a fluoropolymer typically used for seals, gaskets, valve seats and lined equipment. The compatibility between these two is therefore an important consideration for engineers and procurement teams selecting containment, transfer, or processing equipment.
Practical recommendation
No resistance data is available for ECTFE/ETFE in contact with Chlorine. Before using this combination, consult the material manufacturer or conduct independent testing.
Did you know?
The ratings shown here apply to pure Chlorine in contact with the base fluoropolymer. In real-world applications, additives, pigments, and fillers in the material can shift resistance in either direction.
Materials rated A or B at 20 °C
Based on the row for 97 %, 20 °C.
- Fluoropolymers
- PTFE A, PVDF A, FEP A
- Elastomers
- Viton (FPM) A
- Metals
- SS 316 A, SS 304 A
About ECTFE/ETFE
ECTFE and ETFE are tough fluoropolymers with broad resistance. Hot amines and some chlorinated solvents at elevated temperature are their main limits.
Rating scale
- A very good resistance
- B good resistance
- C limited resistance
- D not resistant
- – no data
- K no general statement possible
A rating marked * is an estimate in the source, not a test result. An estimate is given as one value without a temperature.
About this data
The ratings come from the chemical resistance list published by Bürkle GmbH, which compiled them from raw-material manufacturers’ data. They describe laboratory tests on the raw material at 20 °C and 50 °C.
A finished part also sees pressure, mechanical stress, welds and mixtures that a laboratory test does not. Treat the rating as a first filter and test under your own conditions before relying on it.