Rating
| Concentration | 20 °C | 50 °C | Remark |
|---|---|---|---|
| technical grade | D | D |
Material comparison at 20 °C
Resistance overview
NBR is not resistant (D) to Crotonaldehyde at technical grade and should not be used in direct contact. The chemical is expected to cause rapid degradation, which can include dissolution, cracking, severe swelling, or complete structural failure of the material.
Application context
Crotonaldehyde is commonly encountered in coatings and paints and chemical synthesis. NBR (Nitrile butadiene rubber) is an elastomer typically used for seals, O-rings, hoses and flexible connections. Since Crotonaldehyde is flammable, material selection must also consider the risk of static charge buildup and the need for proper grounding in storage and transfer systems.
Practical recommendation
NBR is not recommended for use with Crotonaldehyde. The D rating indicates that the material will suffer rapid and severe degradation, which may include cracking, dissolution, severe swelling, or complete structural failure. Using this combination risks equipment damage, leaks, and potential safety incidents. Consider using HDPE, PP, FEP instead, which are rated A for this chemical and offer reliable long-term performance.
Did you know?
Nitrile butadiene rubber is commonly chosen for seals, O-rings, hoses and flexible connections because of its combination of chemical resistance, mechanical strength, and cost-effectiveness.
Materials rated A or B at 20 °C
Based on the row for technical grade, 20 °C.
- Thermoplastics
- HDPE A, PP A, Nylon (PA) B, Acetal (POM) B
- Fluoropolymers
- PTFE A, PVDF A, FEP A
- Elastomers
- EPDM A
- Metals
- SS 316 A, SS 304 A, Aluminium A
About NBR
Nitrile rubber resists mineral oils and fuels. Ketones, esters, chlorinated solvents, strong oxidisers and ozone attack it.
Rating scale
- A very good resistance
- B good resistance
- C limited resistance
- D not resistant
- – no data
- K no general statement possible
A rating marked * is an estimate in the source, not a test result. An estimate is given as one value without a temperature.
About this data
The ratings come from the chemical resistance list published by Bürkle GmbH, which compiled them from raw-material manufacturers’ data. They describe laboratory tests on the raw material at 20 °C and 50 °C.
A finished part also sees pressure, mechanical stress, welds and mixtures that a laboratory test does not. Treat the rating as a first filter and test under your own conditions before relying on it.