Rating
| Concentration | 20 °C | 50 °C | Remark |
|---|---|---|---|
| 10 % | – | – | |
| saturated | B | B |
Material comparison at 20 °C
Resistance overview
PP shows good but limited resistance (B) to Sodium Peroxide at saturated at 20 °C. The material can be used in contact with this chemical, but minor effects such as slight swelling or a small reduction in mechanical properties may occur over extended exposure periods. Regular inspection of components in service is advisable. The rating remains stable between 20 °C and 50 °C, which means this material can also handle moderately elevated process temperatures without additional risk.
Application context
Sodium Peroxide is commonly encountered in waste treatment and water disinfection. PP (Polypropylene) is a thermoplastic typically used for tanks, piping, containers and liners. Because Sodium Peroxide is classified as corrosive, the choice of containment material is especially critical to prevent leaks, equipment damage, and safety hazards.
Practical recommendation
No resistance data is available for PP in contact with Sodium Peroxide. Before using this combination, consult the material manufacturer or conduct independent testing.
Did you know?
Polypropylene is commonly chosen for tanks, piping, containers and liners because of its combination of chemical resistance, mechanical strength, and cost-effectiveness.
Materials rated A or B at 20 °C
Based on the row for 10 %, 20 °C.
- Thermoplastics
- PVC Rigid A, LDPE A
- Fluoropolymers
- PTFE A, PVDF A
- Elastomers
- EPDM A, Viton (FPM) A
- Metals
- SS 316 A, SS 304 A
About PP
Polypropylene resists most acids, alkalis and salt solutions. Concentrated oxidising acids, chlorinated solvents and aromatic hydrocarbons attack it, and it turns brittle below about 0 °C.
Rating scale
- A very good resistance
- B good resistance
- C limited resistance
- D not resistant
- – no data
- K no general statement possible
A rating marked * is an estimate in the source, not a test result. An estimate is given as one value without a temperature.
About this data
The ratings come from the chemical resistance list published by Bürkle GmbH, which compiled them from raw-material manufacturers’ data. They describe laboratory tests on the raw material at 20 °C and 50 °C.
A finished part also sees pressure, mechanical stress, welds and mixtures that a laboratory test does not. Treat the rating as a first filter and test under your own conditions before relying on it.