Rating
| Concentration | 20 °C | 50 °C | Remark |
|---|---|---|---|
| 3 % | A | – | |
| 30 % | C | – | |
| 90 % | C | – | |
| 100 % | C* | – |
* estimated rating, given in the source without a temperature
Material comparison at 20 °C
Resistance overview
The resistance of EPDM to Hydrogen Peroxide is concentration-dependent. Across the 4 tested concentrations (3 %, 30 %, 90 %, 100 %), the 20 °C rating ranges from A at lower concentrations to C at higher ones. This means engineers must verify which concentration their process actually involves before relying on a single rating. The rating remains stable between 20 °C and 50 °C, which means this material can also handle moderately elevated process temperatures without additional risk.
Application context
Hydrogen Peroxide is commonly encountered in water disinfection and bleaching. EPDM (Ethylene propylene diene rubber) is an elastomer typically used for seals, O-rings, hoses and flexible connections. Because Hydrogen Peroxide is classified as corrosive, the choice of containment material is especially critical to prevent leaks, equipment damage, and safety hazards.
Practical recommendation
EPDM has limited resistance to Hydrogen Peroxide and should only be used for short-term or intermittent contact at ambient temperature. The C rating means the material undergoes noticeable changes — swelling, loss of strength, or surface degradation — that make it unsuitable for permanent installations. For prolonged or continuous exposure, HDPE, LDPE, Polycarbonate offer significantly better resistance and are rated A.
Did you know?
The chemical resistance of EPDM depends not only on the chemical concentration but also on exposure time, mechanical stress, and the presence of other chemicals in the mixture.
Materials rated A or B at 20 °C
Based on the row for 90 %, 20 °C.
- Thermoplastics
- HDPE A, PP A, PVC Rigid A, LDPE A, Polycarbonate A, Polystyrene A, Polysulfone A, PMP A
- Fluoropolymers
- PTFE A, PVDF A, FEP A, ECTFE/ETFE A
- Elastomers
- Viton (FPM) A
- Metals
- SS 316 A, SS 304 A
About EPDM
EPDM resists water, steam, alkalis, ketones and alcohols. Mineral oils, fuels and aromatic solvents swell it severely.
Rating scale
- A very good resistance
- B good resistance
- C limited resistance
- D not resistant
- – no data
- K no general statement possible
A rating marked * is an estimate in the source, not a test result. An estimate is given as one value without a temperature.
About this data
The ratings come from the chemical resistance list published by Bürkle GmbH, which compiled them from raw-material manufacturers’ data. They describe laboratory tests on the raw material at 20 °C and 50 °C.
A finished part also sees pressure, mechanical stress, welds and mixtures that a laboratory test does not. Treat the rating as a first filter and test under your own conditions before relying on it.