At a glance
Based on the row for 100 %, 20 °C.
- Rated A, very good resistance
- PTFE, PP, PVDF, PVC Rigid, Viton (FPM), SS 316, SS 304, LDPE, FEP, Nylon (PA), Acetal (POM), Polysulfone, PETG (13)
- Rated B, good resistance
- Aluminium (1)
- Rated C, limited resistance
- NBR, Polycarbonate, PVC Flexible, Polystyrene (4)
- Rated D, not resistant
- EPDM (1)
- No data in the source
- HDPE, ECTFE/ETFE, Silicone, PMP, SAN
- Rated lower at 50 °C than at 20 °C
- PP (A → C), LDPE (A → C)
Based on the row for 100 %, 20 °C.
Rating profile by material family
Effect of temperature, 20 °C to 50 °C
Substance
- Hazard symbols in the source
- N (dangerous for the environment) (pre-GHS European symbols; check the current safety data sheet)
- Concentrations listed
- 100 %
- Name in the source (German)
- Rohöl
Resistance table: Crude Oil, 100 %
| Material | 20 °C | 50 °C | Remark |
|---|---|---|---|
| Thermoplastics | |||
| LDPE | A | C | |
| PP | A | C | |
| PVC Rigid | A | – | |
| PVC Flexible | C | – | |
| Polystyrene | C | – | |
| Polycarbonate | C* | – | |
| PETG | A | – | |
| Acetal (POM) | A | – | |
| Nylon (PA) | A | – | |
| Polysulfone | A | – | |
| Fluoropolymers | |||
| PTFE | A | A | |
| FEP | A* | – | |
| PVDF | A | A | |
| Elastomers | |||
| EPDM | D | D | |
| Viton (FPM) | A | – | |
| NBR | C | C | |
| Metals | |||
| SS 316 | A* | – | |
| SS 304 | A* | – | |
| Aluminium | B* | – | |
* estimated rating, given in the source without a temperature
Not rated in the source, so not in the table: HDPE, PMP, SAN, ECTFE/ETFE, Silicone
Rating scale
- A very good resistance
- B good resistance
- C limited resistance
- D not resistant
- – no data
- K no general statement possible
A rating marked * is an estimate in the source, not a test result. An estimate is given as one value without a temperature.
About this data
The ratings come from the chemical resistance list published by Bürkle GmbH, which compiled them from raw-material manufacturers’ data. They describe laboratory tests on the raw material at 20 °C and 50 °C.
A finished part also sees pressure, mechanical stress, welds and mixtures that a laboratory test does not. Treat the rating as a first filter and test under your own conditions before relying on it.
Chemicals with a similar resistance profile
Same 20 °C rating on the share of materials shown.